Corrugated single side machine ZH-SF New High Quality Stable And Safe Electric St

China High Exit Price of 500 Type Single Side Corr

Single side corrugating machine adopts cover suction structure and is equipped with high-pressure strong fan. The air source and electrical control are centralized in the same operation cabinet, the operation side is fully enclosed and covered, high-quality resin sand casting, and the wall panel thickness is 200mm. It adopts independent gearbox and universal joint transmission structure. A lifting trolley is installed on the conveying overpass, which can be used to take out the tile roller assembly and pressure roller when necessary, which is convenient and fast. The gluing roller unit adopts an integral outward moving structure, which can be moved out of the machine as a whole during maintenance, so as to improve the work efficiency.The spray and humidity control devices are equipped to maintain good deformation stability and avoid dry cracking. It adopts automatic circulating glue supply system and double pneumatic cylinder pneumatic glue feeding device, which has good cushioning effect. The gluing part adopts an integral sliding plate structure, and the surface of the gluing roller is engraved with 32 line pit reticulation after fine grinding and plated with hard chromium. The corrugated roller is made of 48crmo alloy steel, and the diameter of the corrugated main roller is ¢ 320mm. After quenching and tempering → rough turning → fine boring of the inner hole → drying and installation of the shaft head → welding → tempering and stress removal → fine turning → rough grinding → medium frequency quenching → fine grinding of the CNC grinder.The main force is driven by variable frequency motor, which is energy-saving, efficient and low failure rate. The gluing width is adjusted electrically to adapt to the change of base paper width. The gluing amount is adjusted electrically, displayed and operated on the touch screen, and the gluing gap is transmitted through the encoder, with high accuracy.The drive reduction gearbox adopts oil immersion lubrication to reduce noise, universal joint transmission and isolate the power source. The lifting of upper tile roll, pressure roll and rubber coating roll are pneumatically controlled. The paper guide adopts vacuum adsorption and is equipped with air volume adjustment device to maintain the stability of corrugated type at high speed. The bearings of tile roll and pressure roll are lubricated with high temperature resistant grease, and the glue coating part adopts automatic circulating glue supply, The upper and lower corrugating rollers are made of 48crmo high-quality chromium molybdenum alloy steel. After heat treatment, the hardness is ground on the surface of hrc58o-60o, and the surface of rubber coated roller is treated with anilox engraving and chromium plating,Manual or electric glue separating device, the glue coating department can stop running independently or not, and the main motor is controlled by frequency conversion